Arturia JUPIITER-8V User Manual download pdf (Page 57)

___________________________________________________________________________________

ARTURIA – JUPITER-8V – MANUAL - EN

Assing mode section

Attention! Only the volume envelope will be used by the hold function. That allows you to bring live to the sound while

keeping the envelope free for the filter.

6.1.11 The Tune section

Among these parameters you will find: the general tune of the Jupiter-8V, the detune option for the

voices and a 440 tone to tune the Jupiter-8V.

The “tune” parameters

TUNE : knob to set the general tune of the synthesizer

V.DETUNE : setting the amount of detune of the polyphonic voices

Notice! The detune knob of the polyphonic voices is very useful to make out-of-tune sounds in the "unison" mode. It will

sound a little like the effect of a chorus. When the "Unison" is not active, this parameter brings again a little more

instability to the tune of the oscillators, a typical characteristic of the original machine.

6.1.12 The wheels

The wheels, situated to the left of the virtual keyboard, allow to control the (« PITCH ») of the

oscillators or the amount of modulation by the LFO(« MOD »)

PITCH : Controls the pitch of the two Oscillators

MOD : Button to control the LFO modulation

6.2 Step Sequencer

The sequencer is a 32 step sequencer.

It allows the creation of several melodic lines (when one of the three available modulations is

affecting the frequencies of the VCO) as well as creation of dynamic modulations of other

parameters such as the cutoff frequency of the VCF or on the width of the square waveform of the

VCO's.

Click on the «SEQUENCER/ GALAXY » tab, then click on the « SEQUENCER » tab to bring up the

interface.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 99 100

No comments

Arturia JUPIITER-8V User Manual Page 57