Arturia JUPIITER-8V User Manual download pdf (Page 83)

___________________________________________________________________________________

ARTURIA – JUPITER-8V – MANUAL - EN

 On the envelope ADSR situated to the right side of the filter, increase the attack time to a

value close to "100MS". Lower the knob of the Sustain (set it to a value around "200MS")

and, finally, lower the Sustain toward "0.0.600.000". The maximum level of the cut off

frequency is thus reduced.

Increase the attack time

 Increase the position of the "PWM" selector (for "Pulse Width Modulation") to the center of

his range. Place the situated switch to the right of the "PWM" selector on the position "LFO".

Now it is set to modulate the width of the square with the LFO.

Increase the position of the "PWM" selector

 Increase the position of the LFO "Rate" slider to a position around 3 Hz. The achieved effect

will be comparable to a chorus effect.

Increase the position of the LFO "Rate" slider

 At this stage, you can add a little "Stereo Delay" effect to your tone in order to make it

sound wider.

 Open the page "Effects" situated in the top panel of the Jupiter-8V.

 In the first "Patch" slot (at the bottom of the connection diagram of the effects), choose the

"ST Delay".

 Set the times ("Time") for each of the two sides of the stereo delay.

 You also can adjust the numbers of repetitions ("feedback") to your convenience.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 99 100

No comments

Arturia JUPIITER-8V User Manual Page 83