Arturia JUPIITER-8V User Manual download pdf (Page 48)

___________________________________________________________________________________

ARTURIA – JUPITER-8V – MANUAL - EN

• 1 modulation section (WHEEL MOD) dedicated to the LFO

6.1.1 The oscillators (« VCO 1 et 2 »)

There are two oscillators.

The oscillator controls the basic frequencies and timbres of the Jupiter-8V with the frequency

settings, choice of waveform, and the pulse width associated to the square waveform. These

settings are made either with various knobs (static settings) or by the means of the modulation

sections. These can be activated in the «LFO-MODULATION » section (monophonic modulation by

the LFO) or the « CROSS MOD » (polyphonic modulation using the frequency of oscillator 2 against

oscillator 1).

The oscillators can be tuned and edited separately. They allow selection of 4 waveforms on each

oscillator. The two oscillators have some different waveforms. (E.g. OSC1: triangle, square / OSC2:

white noise, Sine) These waveforms can be used simultaneously. Whether tuned separately or when

using several mixed waveforms, the two oscillators allow you to quickly obtain a rich variety of

sounds.

Two Oscillators

6.1.1.1 VCO 1

RANGE : Switch of the frequency range for VCO 1 ("RANGE"), on four octaves 16', 8', 4', 2'

(unities are indicated in feet, referring to the sizes of the pipes of church organs)

WAVE : Switch for the four waveforms :

• Triangle

• Saw Tooth

• Variable Pulse

• Square

PW : knob to set the impulse width of the square signal (only active when the variable pulse

is selected)

CROSS MOD : knob to set the frequency rate of the modulation between the frequencies of VCO 2

with the ones of the VCO 1

6.1.1.2 VCO 2

RANGE : Switch of the frequency range for VCO 2 ("RANGE"), on four octaves 16', 8', 4', 2'

(unities are indicated in feet, referring to the sizes of the pipes of church organs)

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 99 100

No comments

Arturia JUPIITER-8V User Manual Page 48