Arturia JUPIITER-8V User Manual download pdf (Page 85)

___________________________________________________________________________________

ARTURIA – JUPITER-8V – MANUAL - EN

• Patch effect « St Delay »

 Increase the release time for the second ADSR envelope ("for example to the range of 8000

ms) in order to give the impression of a harp tone.

Increase the release time for the second ADSR envelope

 Increase the cut off frequency of the high pass filter (to the range of 800 Hz)

 Lower the resonance rate of the VCF almost to the minimum.

 Activate the arpeggiator by clicking on the buttons "Range 2" and "Mode UDN". Then play a

chord on your MIDI keyboard. An arpeggio will be heard.

Setting of the arpeggiator

If you work with a MIDI Sequencer and you wish to synchronize the arpegiator to the tempo of the sequencer, click on the

switch "INT / EXT" situated next to the "Rate" fader of the arppegiator then place it toward the bottom into the position

"EXT"

 Click on the selector "Hold Up" if you wish to hold the arpeggio in play mode.

Click on the « Hold Up » selector

We will use the Galaxy unit to modulate the width of the square wave form of the second VCO, the

cut off frequency of the high pass filter and the low pass filter (VCF)

 Open the "Modulations" page situated in the upper panel of the Jupiter-8V. the Galaxy unit

is selected by default.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 99 100

No comments

Arturia JUPIITER-8V User Manual Page 85