Arturia JUPITER-8V 2 User Manual download pdf (Page 105)

ARTURIA – JUPITER-8V – USER’S MANUAL

105

We will use the Galaxy unit to modulate the width of the square wave form of the second

VCO, the cut off frequency of the high pass filter and the low pass filter (VCF)

 Open the «Modulations» page situated in the upper panel of the Jupiter-8V. the

Galaxy unit is selected by default.

Open the «Modulations» page

 Choose the destination parameters of the modulations for LFO1 (Y output) and 2 (X

output):

LFO1  HPF Cutoff

LFO2  VCF Cutoff

 Set the depth of these modulations with the knobs situated next to these

destinations. (Take values around “0.900» for the HPF «Cutoff» and «0.500» for the

«VCF Cutoff»)

Settings of the galaxy unit

If you wish to give space to your sound, add chorus, reverb or delay effects. To do that,

click on «Effects» situated in the upper panel of the Jupiter-8V.

 In the first «Voice» effect slot (at the top of the connection diagram for the effects),

choose «Chorus / Flanger». This will be placed between the VCO and the filters.

 Set the speed of the chorus frequency with the («Rate») knob to your convenience

 You also can adjust the numbers of repetitions («feedback») to your convenience.

 Set the «dry/wet» knob of the chorus in a manner to balance between the original

and the effected sound.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 124 125

No comments

Arturia JUPITER-8V 2 User Manual Page 105