Arturia JUPITER-8V 2 User Manual download pdf (Page 104)

ARTURIA – JUPITER-8V – USER’S MANUAL

104

• An ADSR envelope connected to the amplifier

• The Galaxy module

• The Arpeggiator

• Voice effect » Chorus / Flanger »

• Patch effect » St Reverb »

• Patch effect » St Delay »

 Increase the release time for the second ADSR envelope (for example to the range

of 8000 ms) in order to give the impression of a harp tone.

Increase the release time for the second ADSR envelope

 Increase the cut off frequency of the high pass filter (to the range of 800 Hz)

 Lower the resonance rate of the VCF almost to the minimum.

 Activate the arpeggiator by clicking on the buttons «Range 2» and «Mode UDN».

Then play a chord on your MIDI keyboard. An arpeggio will be heard.

Setting of the arpeggiator

If you work with a MIDI Sequencer and you wish to synchronize the arpegiator to the tempo of the

sequencer, click on the switch «INT / EXT» situated next to the «Rate» fader of the arppegiator then place it

toward the bottom into the position «EXT»

 Click on the selector «Hold Up» if you wish to hold the arpeggio in play mode.

Click on the « Hold Up » selector

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 124 125

No comments

Arturia JUPITER-8V 2 User Manual Page 104